Nuts and Bolts

jymmiejamz

Founding Member
Callsign: KN4JHI
I was thinking it would be nice to start compiling a list of the sizes of nuts and bolts commonly used. I put in an Ashcroft transfer box recently and it had all new hardware which inspired me to do the same when resealing a transfer box. I know a lot of people on here are rebuilding their own trucks (or customer trucks) so we should get a list going for those who want to take it to the next level.

I spent $28 to buy all of the bolts for the transfer box I did. All fasteners came from Belmetric (thanks to whoever recommended this company in another thread).


IMG_4466.jpg


PTO cover - M10-1.5 x 40mm - qty 6 (eliminates 1 stud)

Lower plate - M8-1.25 x 25mm - qty 10

Front side plate - M8-1.25 x 25mm - qty 7

CDL plate - M8-1.25 x 25mm - qty 3

Front housing - M8-1.25 x 25mm - qty 7
M8-1.25 x 90mm - qty 1

Rear housing - M10-1.5 x 30mm - qty 5
M10-1.5 x 45mm - qty 1

Shift lock cover - M6-1.0 x 20mm - qty 4

Hi-Lo shift housing - M8-1.25 x 55mm - qty 6

Transfer box to trans- M10-1.5 x 35mm - qty 2
M10-1.5 x 40mm - qty 2
M10-1.5 x 45mm - qty 1
 

jymmiejamz

Founding Member
Callsign: KN4JHI
I would love if someone had all of the hose clamp sizes for V8 (v belt and serpentine belt) as well as 200/300 Tdi. I hate those crappy hose clamps that every auto parts store sells and it looks like Belmetric has some nice ones that use a 6mm hex like the factory clamps.
CR16N.jpg
 

jymmiejamz

Founding Member
Callsign: KN4JHI
As it turns out, Belmetric sells Norma hose clamps who were the original supplier of hose clamps for NAS Defenders. I grabbed some sizes off of a ‘94 (V8/v belt/14CUX).

8-16 throttle body heater hoses - qty 4

8-16 bleed hose from rad to expansion tank -qty 2

32-50 upper and lower radiator hoses - qty 4

20-32 heater hoses (both sides of heater pipes) - qty 8

20-32 flame trap - qty 1

70-90 intake hose -qty 2
 

jymmiejamz

Founding Member
Callsign: KN4JHI
Does anyone have a good source for Pozidrive screws? I’m looking for ones that work for the grill, headlamp surrounds, wing top vents, ect..
 

WreckITFrank

Well-known member
YRM has a bag of small pozi stainless screws for dirt cheap. Too small for grill. I eventually changed them out for black stainless standard screws from McMaster. I use them for everything now and replaced the surround screws, vent tops, and interior dash screws with the black.
 

WreckITFrank

Well-known member
YRM has a bag of small pozi stainless screws for dirt cheap. Too small for grill. I eventually changed them out for black stainless standard screws from McMaster. I use them for everything now and replaced the surround screws, vent tops, and interior dash screws with the black.

#8 x 5/8

#10 x 5/8

#12 x 5/8
 
Top