my truck runs at about 178 and MOD heater runs great!...rarely have to use fan higher than 1 or 2 setting.
there was/is a "winter / summer" knob on the side of my MOD heater box. not any mention of it in manuals...I end up leaving mine on summer..but there is a winter setting. I noticed that...
Yes, Installed my around sept / october. some of my build pix in my instagram. @braveheart_d90
I also created some 3d print files to meet my needs - stl's available if wanted.
Quality - I give 4.5 stars - well made, well packaged
Ease of install...much easier than my chassis swap or r2.8...
36” kobalt tool chest set
On sale for $498
Get additional 20% off by signing up for Lowe’s credit card
$700 set for $400
Blue only on sale
P/n’s 5071912 & 5071913
I use the MXT275..mounted on cubby next to seat. all controls are on the handheld mic, which is mounted on the fuse box panel. small, out of hte way. I have a small external antenna mounted on the roofrack behind the sunroof
https://www.thingiverse.com/thing:4556775
just need to create your reversed (forward facing) ducts.
the only issue...I am not sure how (what app) to modify the .obj file (I use Fusion3d)
What happens if you connect a trailer? will hitting the brakes shut off all the lights? (thats not good). also...the amazon link states not for LED...but your reciever light is LED (is it not?)
I cant remember if I posted here...but I posted on my IG. @Braveheart_D90
I did a chassis swap and installed a CJ-5 15gal tank. There are 3 flavors...I went with the version with a 1" inlet and 5/8" vent.
(I didnt go NAS tank...mostly due to the expense....as my 90 is far from stock...I wasnt so...
I filled up today!
the most I have put into my 90....soooo close to $100 - still had 4gal left
9394 miles since the R2.8 swap - total average of 18.02mpg
12gal factory + 15gal aux tank
at first, AC was not as frigid as I would like...I will double check the pressures - I added the estimated amount of freon - but as my lengths of hose are longer than standard, I may need some more. I added more refrigerant to bring pressure up to where they should be (midrange) for the ambient...
#8 The final Home stretch!!!
ducts all run, vents tested for air flow, final location fitting - make sure all electrical is reconnected and grounded....time to put the dash together! I forgot to take a picture of the "almost completed dash"...but got the Raptor center console re-installed and...
#7b. More custom parts:
Now I needed a defrost manifold to support the two main defrost vents and the new door vent, driver side lower dash interior hose connection, Driver side Tee to main vent and lower dash vent and lastly a custom lower dash (exterior) to a "Nostalgic AC" dash vent.
#7. 3D Printing custom parts
I wanted to maximize the air distribution and velocity from the MoD unit to the new ducts. I decided to go with 2x 2.5" "Vent" ports and a single-shared 1.75 port for defrost capabilities. Drivers side and Passenger side vents would each have their own port from...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.