Hello again! 200 TDI
recent boost gauge installed - not getting boost over 2-3
-Have shortened the actuator arm with no change
-the wastegate moves freely with the arm off
-have pulled off the air hose - the turbo fins look good - there is no play in the shaft and no oil present
-Have attached...
Appreciate the input
They hoses have been vacuum checked and the intercooler pipes were replaced with no change. Engine itself was rebuilt. I do realize the turbo is an issue that needs to be sorted. Tiny bit of smoke on start and no smoke while driving. I guess I should also consider if the...
Yes, I have an oily rear on my 200 TDI D90
Finally getting to drive it some and Im noticing an oily film over the back window and the entire upper back of the truck.
I have a drivers side exhaust.
I have some degree of leak from the transfer case seal (which was just redone by a reputable shop...
I promise you I've studied the wiring diagrams!! The wire is certainly easier to follow on it than on the truck! I appreciate your detailed response - I guess my biggest question is whether I can access this loom from the dash? It just seems logical to believe that when the installers ( they...
Now back to me-
Aghhhh!
Frustrating!
Bulbs are etested and both filaments good
Brake light receptacles are new/grounds are good
With the switch bypassed, I have power leaving but not getting to the brakes
My issue is in tracing the wires- they go into the firewall and then where? I think they...
Update and back to square 1
I removed the switch - and was finally able to connect the two leads together - still no brake lights
Tested both sides of the switch with vehicle on and brake depressed and there is good voltage at each
I'm starting to think that when my new gauges were installed...
Thanks for the guidance!
I get voltage from the wire going into the spade
Was not getting voltage out with brake down
Took the cap off and found the reservoir was fairly gunked up
I cleaned it out and reconnected everything
Now I get just under 11 volts coming out of the switch
But still no...
Sorry I am new to electrical things
To test this do I use a multimeter with the positive on the spade coming out of the hot lead on the top of the reservoir? Do I just ground the negative?
Car doesn't need to be running - just in on key position?
I am new to a 1990 200 TDI.
Driving home yesterday in front of a buddy who informed me that my brake lights were not working.
The lights do turn on when I put on my parking or headlights but not do not get brighter when I put on the brake.
Cursory look at the connections and all looks ok.
The...
I use Nationwide in NC. Have other autos/home with them
I had no issues insuring my 1991 D90 ROW. I did obtain a vehicle appraisal to help them attach a value to it and prove its worth it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.