Recent content by Wilboro

  1. Wilboro

    Welding Aluminum

    I bought a used spool gun for my millermatic 252 to do repairs on my rear tub, it worked out but certainly was pushing the limits of what's possible with the thin aluminum, even though I was mainlu doing plug welds. I ended up using copper heat sinks behind every plug. Once you get a bit...
  2. Wilboro

    Q: Installing Mantec Tire Carrier

    You didn't get the model for a later pressed Td5/Puma door did you? The door plates are different I believe.
  3. Wilboro

    Used 300Tdi Crankshaft Pully

    I agree I doubt two bolts will cut it. The amount of force is serious, I was questioning if the four bolts were going to take it. I had my friend laser cut me these two pieces I designed and then I welded spacers between the two plates. This is cut from 1/2"
  4. Wilboro

    Front Axle Casing - Plug?

    Mine runs up the radius arm and snakes in the engine bay and goes through a metal loop on the top back of the engine.
  5. Wilboro

    Clutch pedal box seal (lower)

    Yes that's adhesive backed I would say. My preference (and what I did)would be to stick it to the pedal box then you can move make any fine adjustments without it stuck to the bulkhead. Plus you know the seal will be in the right place, if you stick it to the bulkhead you could potentially...
  6. Wilboro

    110 300Tdi Exhaust

    The hangers are the original ones from my 300tdi chassis, I just had them galvanized. The mounting points on the chassis may look slightly different than on the original stock chassis (this chassis is a Marsland ) but they bolted right back on no problem. What year is your chassis?
  7. Wilboro

    110 300Tdi Exhaust

    Here are the three on a 110. If you have a cat there is a fourth.
  8. Wilboro

    What have you done to your Land Rover

    A very productive first day of spring. I Renewed my plates, put road insurance back on, did a quick brake bleed and took the first road drive in almost 3 years. Very satisfying after all the toil to get to this point.
  9. Wilboro

    110 300Tdi Exhaust

    Well I don't drive it.....garage queen. In all seriousness I hope to be getting it dirty in a few weeks, three years off the road for restoration is a long time.
  10. Wilboro

    110 300Tdi Exhaust

    Couple shots from the exhaust I installed this past fall.
  11. Wilboro

    bonnet catch adjustment?

    Hmm that's weird. If it's off more than you can slide those adjustable guide bits I wonder if your bonnet is slightly off center? Pictures?
  12. Wilboro

    bonnet catch adjustment?

    You mean the catch sits too close to the front of the vehicle? I just bent mine by hand a bit, it's pretty flexible.
  13. Wilboro

    bonnet catch adjustment?

    Yep I just got mine all adjusted and had to do a bunch of messing about. You can also gain a bit more adjustment if need be by loosening the bonnet hinge bolts and moving it a bit back there.
  14. Wilboro

    bonnet catch adjustment?

    I think there are different generations of the latch, on mine if you remove the grill you'll find two m6 bolts that run vertical and pass through the two slam panel support arms and thread into the latch plate. If you loosen those two bolts you should be able to move the latch plate around a...
Top