WANTED : Rear Window Trim - ROW90, Pre Puma

[FLY CUBS]

Looking for a set of these in good condition:

 

[FLY CUBS]

Bump - still looking for a set or any leads on aftermarket. Any feedback on the Masai Sets?

 

[JimC]

I have a set that are “mostly good” with a section of damage in the lower passenger side corner on the long piece by the back window. if you have jump seats or sometching else mounted there site very inobtrusive, but if you’re trying to make a show truck then you won’t be satisfied. if you’re interested enough I can send pix.

 

[FLY CUBS]

I have a set that are “mostly good” with a section of damage in the lower passenger side corner on the long piece by the back window. if you have jump seats or sometching else mounted there site very inobtrusive, but if you’re trying to make a show truck then you won’t be satisfied. if you’re interested enough I can send pix.

Jim- thanks. I have a lead on a slightly nicer set, but if that falls through I'll reach out for some pics. Thanks again for the reply.

 

[cdmbrennan]

I have a set that are “mostly good” with a section of damage in the lower passenger side corner on the long piece by the back window. if you have jump seats or sometching else mounted there site very inobtrusive, but if you’re trying to make a show truck then you won’t be satisfied. if you’re interested enough I can send pix.

Hi Jim,

I'd be interested in seeing pics and knowing more details- specifically the width of the "wider" section on the side panels. I didn't install the windows in my ROW, and am only assuming they're in the correct place- would want to be certain...thanks in advance.

 

[JimC]

There is the little broken bit in the bottom corner. The rear corner trim is not installed in this pic. I took pictures of the measurements for where the windows should be, but unfortunately the app has turned the pix again. The dimensions are:
From front edge: 19cm
From bottom: 3cm
from rear corner: 14.5cm

I think if you’re close then stick trims will fit.

 

[cdmbrennan]

Thanks- will measure and PM you if they'll work!