NAS V8 Raised air intake

pfshoen

Well-known member
I had one built for my RHD V8 using parts for one for a Tdi. Need to fab the plate that replaces the wingtop vent, with a pipe that goes into engine bay and one that runs along the wingtop toward the windshield.
Good thing about fabbing one is that you choose the pipe diameter. I bought one of the old RN V8 snorkels and the diameter was less than the intake on the 300 Tdi I installled it on. The one I had fabbed matches the Tdi diameter.
The V8 type snorkel will mount without cutting any new holes in the body, unlike every other type available.
 

El Pinchi

Well-known member
my friend Ed just started reproducing them in Lake Elsinore CA. He used mine off my NAS110 as a model and has a water jet biz next to his make the flat, fender piece. I don’t think he’s started making in bulk yet…he just made one for a customer of his. He’s not on this board only the other one so I’ll let him know to respond to this. Only for LHD NAS model. Hope that helps.
 
Last edited:

KND

Well-known member
my friend Ed just started reproducing them in Lake Elsinore CA. He used mine off my NAS110 as a model and has a water jet biz next to his make the flat, fender piece. I don’t think he’s started making in bulk yet…he just made one for a customer of his. He’s not on this board only the other one so I’ll let him know to respond to this. Only for LHD NAS model. Hope that helps.

Perfect, I have LHD NAS 90, I would buy one off your friend if he is making another one. Thanks.

Cheers,
 

DefendersNW

Well-known member
I've fabbed up a few intake solutions along the same lines - both wing top and side intake with a wider stance to clear roll cage
 

Special_Ed

New member
Callsign: Ki6ojv
Looking for these?
 

Attachments

  • IMG_20230322_123420509_HDR.jpg
    IMG_20230322_123420509_HDR.jpg
    186.1 KB · Views: 92
  • IMG_20230322_123429613_HDR.jpg
    IMG_20230322_123429613_HDR.jpg
    147 KB · Views: 90
Top