Napalm00
Technical Excellence Contributor
This is the head I just swapped off my truck. KNOWN GOOD, from a running truck that did 70 all day. Head was pulled to put on a homemade performance ported and rebuilt spare head, I was also overdue for a decoke service.
the base is dead flat, I couldn't fit a .002 feeler under it with a machinist straight edge on any of the six measurement paths.
Comes with:
The entire valve train in good shape with no wiped arms
Set of bolts with 2 uses on them
(not pictured)
Issue is the small crack that is on cyl 3 between the injector and the glow plug ports. Frankly I ran it this way for nearly 100k, as it had this crack when installed, was pressure tested as good when installed.
Shipping is on your dime from zip 95008.
calculate your shipping here :
https://postcalc.usps.com/
Dimensions: 24x12x10
25lbs
$450 ready to run just supply hardware.
the base is dead flat, I couldn't fit a .002 feeler under it with a machinist straight edge on any of the six measurement paths.
Comes with:
The entire valve train in good shape with no wiped arms
Set of bolts with 2 uses on them
(not pictured)
Issue is the small crack that is on cyl 3 between the injector and the glow plug ports. Frankly I ran it this way for nearly 100k, as it had this crack when installed, was pressure tested as good when installed.
Shipping is on your dime from zip 95008.
calculate your shipping here :
https://postcalc.usps.com/
Dimensions: 24x12x10
25lbs
$450 ready to run just supply hardware.
