Search results

Who supplies the best quality, Paddock Spares or Bearmach? I'm guessing I should be looking for Timken bearings but all I see are blue bags or nothing in the descriptions. Any other "kits" from different suppliers out there? I'm also doing swivel ball seals. TIA

So there I was...off to get some exhaust work done this morning and it died on me. Background: It's been running sluggish and at times is hard to start. This morning it took a couple minutes of stumbling to get it going. When it did get going, it felt like it was at half power. Then it...

Any 2.8 TGV gurus out there? I have about 1k miles on the engine, although it has been sitting for about 5 years. I finally finished the rebuild and have been driving it around town...only twice now. Earlier today I noticed that it didn't shut off exactly when I turned the ignition off. It...

I'm trying to start a small veteran owned business and have some questions about obtaining an SBA loan...actually, it may be two....one for a piece of real estate and the other for inventory. I don't know where to start and haven't had any luck with local SBA folks here in TX. I thought I'd...

I've had a starting issue with my 2.8TGV for years....it started just before I began rebuilding the 110 5 years ago. It doesn't start instantly anymore (engine only has 1k) and takes minutes to start. Sometimes this requires bleeding the system in various ways. I noticed that when I hand-prime...

Has anyone installed a trans temp gauge on their ZF4HP22? I'm not sure if it has a location on the trans housing for the sender...or maybe its best in the pan?

I've had this problem for a long time. Granted, my 110 has been in storage or the garage for the past 5 years after installing the TGV. While I've been restoring it, I've tried to get to the bottom of this weird delayed-start issue. Initially when I had the engine installed, it started in a...

I've layed down my epoxy and high-build surfacer. While block sanding, in a few small spots I have gone down to the aluminum (rivets, some edges and curves). My question is, can I apply an etch primer from a spray can to hit those spots? I really don't want to mix up more epoxy primer, but I...

I'm on the fence. I should have my 110 painted in a couple weeks (priming now) but not sure if I want to paint the arches body color or not. The color is close to Keswick green. My other option is to go with a flat/matte black. For those that have painted them, do I need to use a plastic...

Just looking for a like-new or take off Puma / XS grill. Color isn't too important since I'll be painting it. Thanks, Matt