Search results

Left rear and side blinkers don?t flash. However my relay flashes at a normal speed, so it thinks (I assume) it?s encountering the correct amount of resistance. But the bulbs don?t flash (visual inspection says they?re good), so am I deducing correctly that something else is causing this...

Square tubing rack that came with my 110. Structurally solid, needs some cosmetic TLC. Some surface rust under paint, but nothing that's compromising structural integrity. Includes 7 gutter clamps (5 missing). Some rust on light housings and mounts. All four lights work and are included...

My A127 45-amp alternator died. It has two wires to the big post and a small spade connection. If I replace it with a 65-amp alt, does the small spade wire get a new connector and go to the small post? I'm referencing the images here: http://www.rovahfarm.com/defenderignition.htm Or, am I...

I've replaced the bushes on my radius arms and am now attempting to reinstall the arms. I'm having a bugger of a time getting these things on. I've managed getting the middle bolt on, but can't seem to jack the axle around to get the other holes aligned. Any tips?

The passenger seat (LH on my RHD) does not slide. According to the parts catalogue, it looks like my 1987 was the last MY that didn't have a sliding passenger subframe. I'm assuming it won't be an issue installing the LH sliding subframe (MXC5779) built for a later MY, but does anyone have...

Any other woodworkers on here? Just finished this humidor for my brother-in-law for Christmas. Walnut + maple.

My tank made a sucking sound every time I opened the cap. I disassembled and cleaned gunk out of my vented cap and now the vacuum issue is fixed. Now it's created a new issue where it seems it's venting 'too' well. The area around the cap is always moist, regardless of tank level. Is this a...

My shift knob was attached to lever by PO with some sort of black gunk that allows it to easily rotate as well as rattle. What is the factory method (or any of your better methods) for attaching the knob to the lever? I could just epoxy it on, but I want it to be removable in case I need to...