want to ask if anyone has feedback or experience on the following.
i for some reason have two different diameter door top studs. the driver side has the typical straight stud that the plastic sleeve fits over. the passenger side stud had a thicker diameter stud that the sleeve will not fit over. then if i try to replace the thicker studs with the typical straight stud & then sleeve the reach of the two studs is about 1/32 to long to fit in the holes if the bottom half of the door! find this very odd. i did not try and bend the straight stud then fit it with the sleeve trying to make it work as i felt trying to remove it in the future could be a issue. so i left the thicker studs in with no sleeve and tightened the speed nuts & called it a day.
has anyone seen two different thickness door top studs? i thought just the straight stud was the only one.
any feedback would be nice as I'm just wondering
thx
i for some reason have two different diameter door top studs. the driver side has the typical straight stud that the plastic sleeve fits over. the passenger side stud had a thicker diameter stud that the sleeve will not fit over. then if i try to replace the thicker studs with the typical straight stud & then sleeve the reach of the two studs is about 1/32 to long to fit in the holes if the bottom half of the door! find this very odd. i did not try and bend the straight stud then fit it with the sleeve trying to make it work as i felt trying to remove it in the future could be a issue. so i left the thicker studs in with no sleeve and tightened the speed nuts & called it a day.
has anyone seen two different thickness door top studs? i thought just the straight stud was the only one.
any feedback would be nice as I'm just wondering
thx
