lock and fold seat belt installation

[ctflyfish]

Hi - Having a bit of a brain fart, and can't find a picture of what I'm looking for online. I am installing 3 point inertia belts in a 3 door 110. I have lock and fold exmoore seats with buckles already in. My question is where to bolt the bottom part of the 3 point belt. See picture below in red.

Any pictures / info is much appreciated.

I included pictures of work beefing up cage as well.

 

[KGH]

PN 345100 and 345101

bracket that mounts on sill and rearward verticle flange of seatbox, outboard on both sides

 

[KGH]

And in situ. This is why little dimple in side of seatbox. View here is LHS, rear of sill.

 

[ctflyfish]

And in situ. This is why little dimple in side of seatbox. View here is LHS, rear of sill.

Thank you, this might be a dumb question, but isn't that for a 90 or rear of 110 though, where it mounts up against the corner of the rear tub & side, or does it not matter?

 

[KGH]

With the belts you show, thats what you get! Other belts have bracket sewn into that end, or on frame of inertia reel.

Also note, take my advice at your own risk, human to windscreen to tarmac rapid interface is not my responsibility.

 

[ctflyfish]

human to windscreen to tarmac rapid interface

Noted, LOL. This is what I was going off of.