WreckITFrank
Technical Excellence Contributor
Mounting up my roof today and the needed to pull the windshield frame to get rid of a few layers of extra foam tape the PO felt he needed. Once pulled, the lower corners didn't disappoint in a standard defender fashion. The good part from what I can tell is that it does not go down too far. Hard to see in the pics but the rust is only a few inches below the surface, and the back portion towards the dash is pretty solid, and the vent area looks unaffected. Floors are in good shape, as are bulkhead sides.
What is recommended as a brand to to with for a repair piece? Does anyone have one on hand they wont be using. Left side is the what is in need, only a pinhole in the right but will all metal it and frame coat the inside. Happy to buy both if someone has a set they don't need. Also open to any advice from those who have done it. For reference, rest of vehicle is relatively rust free.
definitely a bummer, as i wasn't planning on removing the whole damn dash. fortunately my buddy is a welder, so that wont be difficult just more work than i wanted to do. Thanks in advance.
What is recommended as a brand to to with for a repair piece? Does anyone have one on hand they wont be using. Left side is the what is in need, only a pinhole in the right but will all metal it and frame coat the inside. Happy to buy both if someone has a set they don't need. Also open to any advice from those who have done it. For reference, rest of vehicle is relatively rust free.
definitely a bummer, as i wasn't planning on removing the whole damn dash. fortunately my buddy is a welder, so that wont be difficult just more work than i wanted to do. Thanks in advance.