Search results

I did bench bleed the master. It turns out both front wheel bearings are bad. That was causing my pads to retract causing the issue.

I need some help trying to figure out the cause of a brake issue on my NAS90. I have a 1995 NAS90, when I press the brake pedal it is a 50/50 shot that the pedal just about goes to the floor. If I let off and press it again it is a nice hard pedal. You may get a hard pedal 10 times then it just...

Thanks! I will send Ashcroft a message and see what they have.

Running in the mountains of Colorado the transmission can get hot. Especially when we are pushing 100 degrees.

I am looking for a R380 thermostat housing so I can add a cooler to my transmission. Part number is FTC2867. Thanks Jim

Thanks again for checking.

Thanks for checking!

Looking for someone to take a look at the picture and let me know if the raised part of the output shaft is pressed in far enough. I don't have another R380 to compare it to. Thanks for the help.

Thank you!!! I have been trying to figure this same thing out. Now I can move on to the next thing on the list.

No problem. The good thing is it finally got me to register an account here!

I will take it! Send me a PM.