Recent content by Z.G

Started painting over the weekend. Unlike @erover82, my standards are low and they were good enough for me. Will do some wet sanding on them in the next day or two to get used to it. Wasnt super happy about the color initially but once it dried I took the tunnel outside and the color really...

These are the ones to use with a 1-2" lift - https://www.ridefox.com/product.php?m=truck&partnumber=985-24-005

We've been selling them for a while now, they're just replicas of the Khan wheels but they seem pretty well made

While we have had to warranty older NRP components, they do pretty well with corrosion resistance. But ultimately you're paying for the lifetime warranty, so no need to worry about longevity

It took them 2 generations to make a functional one, too 😅

That’s wild, I’ve never had an issue. I have touched up the black coating every once in a while but never had corrosion start

I haven’t seen them offered stateside, I’ve only ever run/recommended SDO’s galvanized/oxide coated ones that never rust

Having seen the products in person(we’ll be retailing some of them soon), you can purchase with 100% confidence that it’ll exceed expectations. That doesn’t really need to be explained to anyone that follows his build thread

Must be nice!

Personally I'd make my own jumper pipe, the LR ones are absurd money. But we do have PL versions depending on your VIN(they switched in 98, at WA159806) this would be the one https://www.roversnorth.com/parts/pls501_brake_pipe_flex_hose_to_lhf_caliper

I convert all my vehicles to 1/2" - 1/2" shocks, I just prefer the simplicity and never had a failure compared to the many I've seen with studs. It allows you to run basically any universal shock in any length or valving you'd like

Those are the RTE 1/2" conversion towers, I had Simon send me a bare set and had them galvanized with everything else. They're super nice but you can't run the wheelarch suspension covers with them

Shocks finally came in after a few months of waiting. Found the easiest way to install the rears was by removing the tub sides

Negative, we couldn't source any RHD housings new to have these produced unfortunately.

They already make those, Riverhouse puts them on many of his builds, they're a deep offset Wolf wheel