DA1129 | Fulcrum Bracket And Ball Joint

broncoduecer

Technical Excellence Contributor
New in the box DA1129 | Fulcrum Bracket And Ball Joint
$35 shipped lower US.
PM me if interested.
 

rocky

NAS-ROW Addict
Now I need to install it... LOL

If yours is like mine....twenty plus years of stiction.....it was an SOB to get old one out......

Make sure you have replacement bolts. Don't be surprised if you end up torching the old ones out.
 

MountainD

Technical Excellence Contributor
Yep... hence been sitting on replacement for 14 months...lol. I’ll get to it this summer...maybe... mine is just about 20 years... great life though!!!
 

Napalm00

Technical Excellence Contributor
Three "easy" ways to remove it

Hammer and pickle fork in between the bracket and the axle, from the rear

Jack it is all the way and sneak a wrench into the space between the bracket and axle from behind then lower the vehicle

Remove nut then lightly thread back on. Put truck into gear and drive it around kinda rough.



I always use option 1 it takes about five good wacks.

I also usually replace the bolts as they are cheap 1/2in x 6in fine pitch grade 8
 

The Dro

Illustrious
I did one ages ago and I almost kill myself... no joke... the truck rolled forward and hit the ground seconds after I rolled out of under it. I had wheel chocks, towers and the tires under it just in case.

I remember someone here in VA got crushed by his Rover about the same time that shit happened to me.
 

Jeff B

Well-known member
I pulled the cotter pin.... mine was loose from driving around town in 2 days.



The really hard part of this job is the 2 cross bolts....


.
 
Top