Landy_Andy
Well-known member
Made a start on the exhaust system, am using 2.25" stainless steel tube from Columbia Mandrel Bends for the 'Y' pipe, into a 3" Magnaflow muffler. Is a bit more involved than a regular build due to having the 3 link on the front and using the x-member to mount the front drive shaft steady bearing.
Rear will probably be dual 2.5's once I work out the routing of the pipes over the top 4 links. Need to make sure it'll all clear at full bump & flex.
Rear will probably be dual 2.5's once I work out the routing of the pipes over the top 4 links. Need to make sure it'll all clear at full bump & flex.
Last edited: