WTB: 2.25 motor mounts

I am after the mounts, preferably If you have an old series frame and can just cut that section out or have already removed them nicely for a conversion. I'm putting a stock 2.25 gas back into a vehicle converted to chevy iron duke a long time ago.

Better off just making up new ones - dimensions and location information are available

DefendersNW said:

Better off just making up new ones - dimensions and location information are available

Click to expand...

I know that I could. The truck is also next to Briggs's fleet so no issues finding dimensions or anything. Just trying to save hassle of making anything.

Curious as to why someone would cut out the stock mounts for an Iron Duke conversion.
All the ones I did bolt right up to the stock motor mounts on the frame.

Assume this is for an 88 or 109.

RDavisinVA said:

Curious as to why someone would cut out the stock mounts for an Iron Duke conversion.
All the ones I did bolt right up to the stock motor mounts on the frame.

Assume this is for an 88 or 109.

Click to expand...

Yep 88". They cut them off. I don't know why. The truck didn't have a transmission or t-case in it when I got it but was in operational condition with the engine at some point. The mounts are about 6-8" back on the drivers side and further back on the passenger side. I can take pictures when I remove it to show you for educational purposes.