donb
Well-known member
Damn Don. Nice work! Where did you source the turbotechnics turbo? VNT?
Thanks! Mr Randy was he source of the TT VVT - I saw the setup on Matt?s 300tdi and had to have one
Sent from my iPhone using Tapatalk
Damn Don. Nice work! Where did you source the turbotechnics turbo? VNT?
Great work Don. I?m think?n Vermont is on your horizon.
I?m hoping I can get everything done. Still have a lot to do. I?m going to tow the 110 up so I guess I could always load it and hang out if if doesn?t work 100%
Sent from my iPhone using Tapatalk
Flywheel housing studs make the engine install much more difficult.
We never use them and use bolts instead.
You can put long bolts in to line everything up and then use shorter bolts as you pull the engine closer to the transmission.
I?m hoping I can get everything done. Still have a lot to do. I?m going to tow the 110 up so I guess I could always load it and hang out if if doesn?t work 100%
Sent from my iPhone using Tapatalk
I can see them making it tougher to line things up. My only worry is with the cast aluminum piece and bolt length. I may leave the studs and then can pull them if it?s a too hard to line the engine up.
Sent from my iPhone using Tapatalk
The 19J is really hard to like up on a LHD with PS,
It would be fab if the site admins would turn on auto resizing of the pics....
I finally got the flywheel back.
Now would be the time to drill the holes to tap the pins out.
You can get a centering drill bit and drill from the top then once the center is sufficiently started, switch to a proper drill bit and drill the hole smaller than the dowel pin hole.
This will leave the step and hole to drive the pins out.