Looks like the PO wrapped the end of the trans stick in electrical tape then wedged the shift knob onto it. What should be here to hold the shift knob in place?
Mine is installed in the EXACT same manner. Don't know how it got that way, or how it's supposed to be, but I haven't placed this fix very high on my to-do list.... yet. So many other things to do.
If you can find some hose that is the same outer diameter as the knob, and slightly smaller ID than the threaded shaft a ~3/4" piece will work in the same manner as the original.
Mine is installed in the EXACT same manner. Don't know how it got that way, or how it's supposed to be, but I haven't placed this fix very high on my to-do list.... yet. So many other things to do.
Had the same issue with the hi/low knob on the RRC. Couldn?t find the part (to be honest I didn?t look too hard) so I machined a plug from 1/2? hdpe and threaded the center. Thought I?d have to glue it in but the fit was tight and it?s not coming off.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.