NAS D90 switch assembly STC439 (Indicator/Horn/Headlamp)

[rover26c]

Question. Horn and headlamp work, but not the turn signal (left or right). Would anyone know the reason why the turn signal does not work? Thanks in advance.

 

[WreckITFrank]

Maybe it's the tie to the hazard switch? Mine was gummed up and needed a few cycles to get going, but that's after it sat for a while. If the wand is in good order, the flasher and hazard are next steps to try.

 

[John Z]

Could be hazard switch or the relay. Most likely the hazard switch. Does that work?

 

[dkemm]

Question. Horn and headlamp work, but not the turn signal (left or right). Would anyone know the reason why the turn signal does not work? Thanks in advance.

I had the same situation.... I spent 2hours trying to meter all turn signal stalk connections....didnt work. I did some research. this morning, I pulled out the hazard switch to meter those connections. as it turns out, the R turn signal was on when I turned the key....all systems working. It appears that the connection for the hazard switch to connection was/is loose...I can move it and signals stop. my switch is fine (replaced a few months ago) - but the copper pin connections are loose. will see about maybe adding solder to those or see if I can crimp the connector (female) parts.

 

[rover26c]

I just checked and it is the hazard switch. I pulled it a little and it now works. Thanks guys!