Door Grommet for Speakers - MUC6521

[chris snell]

I'm putting together parts to install speakers in my new RN door cards. I have these cards and I'm looking for the grommet that routes the speaker wires from bulkhead to door. My bulkhead has no holes cut in the door jambs and I'm trying to figure out the right way to do this.

Ideally, I would use the MUC6521 grommets but these are NLA. Does anyone have a set lying around? Is there a generic automotive part alternative available somewhere?

Another option is the YQAQ000070:

I believe that this is used on post-2006 trucks but not sure on that. I'm not keen on this option because of the size and shape of hole that I'd have to cut in the bulkhead.

Here are the cards I have. It looks like they have used the YQQ000070 here.

Would love to hear from someone who has added speakers to a truck like mine and see how you did it.

 

[BarryO]

Looks like there's a ton of confusion over the part # MUC6521. The NAS Defender parts catalogue lists this as the part number for the speaker wire grommet. The same number is listed for the Disco2. This sounds "great, Disco2 parts are a dime a dozen". Except they're different parts. I think what a lot (most) are using is the grommet for the SW rear door. It's the right diameter but longer than the originals used on the front door. I thiinnk some people are just shoving the extra length into one of the holes.

 

[4RF RDS]

FWIW I used an old car phone charger cable and just fished it into the hole and put a round grommet in the hole to further protect it. Works great and looks good (IMHO)

 

[Z.G]

Looks like there's a ton of confusion over the part # MUC6521. The NAS Defender parts catalogue lists this as the part number for the speaker wire grommet. The same number is listed for the Disco2. This sounds "great, Disco2 parts are a dime a dozen". Except they're different parts. I think what a lot (most) are using is the grommet for the SW rear door. It's the right diameter but longer than the originals used on the front door. I thiinnk some people are just shoving the extra length into one of the holes.

Correct, most people use the rear door grommet. We sell hundreds of them. They're not a perfect fit, but they work and look correct

 

[javelinadave]

Correct, most people use the rear door grommet. We sell hundreds of them. They're not a perfect fit, but they work and look correct

What's the part number?
Disregard. It is a AMR3963

 

[BarryO]

Correct, most people use the rear door grommet. We sell hundreds of them. They're not a perfect fit, but they work and look correct

Yea, two went to my rig. I recently had to replace mine; I looked at the ones on my Disco2 and they were way to big in diameter.

 

[rlynch356]

i am using this from amazon..

https://www.amazon.com/Door-Wire-Sm...0QNQ0SYQNXX&psc=1&refRID=G805F4BWB0QNQ0SYQNXX

 

[BarryO]

i am using this from amazon..

https://www.amazon.com/Door-Wire-Small-inside-diameter/dp/B078P6DYQM/ref=pd_sbs_263_1/141-0877669-3164623

Nice find. Does is snap into the hole on the pillar OK?

 

[rlynch356]

Yep,