broncoduecer
Technical Excellence Contributor
Will do!Can you do a separate post for this @broncoduecer ? This is too awesome to have just buried in this thread.
Will do!Can you do a separate post for this @broncoduecer ? This is too awesome to have just buried in this thread.
I‘ve used heat shrink tube and created a collar at each end of the tubes as a way to add a little extra stiffness and resilience to the ends. It also presents a tidier appearance than the cut ends especially when using the fabric braided tubing. Might just be voodoo, but I’ve not had any leaky spill back pipes after doing this.
That yellow stuff is exactly what I was using before going Viton. Worked great.
I wonder if Gates makes one of their heat shrink hose clamps small enough for this.
I wonder if Gates makes one of their heat shrink hose clamps small enough for this.
I had mine on and off, but I was lucky enough not to have any of these issues with my spill lines. My cover was actually warped a bit as well, rubbed against the lines.Are you guys running the black rubber insulated engine cover thing? I've had to trim mine back quite a bit. I wonder if the lines get messed up when that thing gets pulled off.