To set the stage, 85 ROW LR110 CSW with 60/40 bench in second row.
Would like to upgrade to a left and right side single seat, hi back, that teenagers can actually sit in.
have looked at the RN upgrades and the Exmoor trim upgrade - like but want to run any other options folks have used.
Q1: Do...
Passing through Charleston, SC, pre-extensive work, circa 2013
Finishing up a fun day with Old North State Land Rover Society’s Uwharrie Expedition 16. Circa 2018
Replaced the a frame pivot, was very simple and all the bolts cooperated. Good use of anti seize previously.
Checked the hub and the drive flanges were also worn significantly. I know that also contributed to the clunk and appeared close to letting go. Good inch or so of slop. Axle splines...
Will give them a shake. I have relatively new polybush on them. My replacement a frame pivot arrived today - thanks, Lav.
Hopefully this will quiet things down.
Much thanks for all the advice. Living, learning and busting my knuckles.
On my 85 LR110, tackling the rear clunk.
Salisbury rear end.
Have looked at a frame and don’t think that’s is it.
Next.
Pulling hub flanges and axle shafts to inspect condition of splines.
Also pulling rear diff to inspect and test off vehicle, to determine if slop is hub-spline or axle-diff...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.