Search results

  1. RDavisinVA

    FS Camper Sink with hot water

    For Sale NTO Teal Camp Sink, never used. 24"X15"X12.5" 12V Water Heater 8.5" diameter stainless steel sink (round part measurement) Tank is copper and is 15"X10"X9" = 5.84 gallons. Comes with drain tube. Faucet is operated manually. This is a nice unit that easily mounts on the fender well or...
  2. RDavisinVA

    GM 292 Straight 6 - Yet another conversion

    292 Production Ancillary Mounts: LHD With AC Saginaw PS Pump, Delco Alternator, and Sanden AC Compressor Note AC Compressor will run dual belts.
  3. RDavisinVA

    GM 292 Straight 6 - Yet another conversion

    292 Production Ancillary Mounts: LHD Without AC: Saginaw PS Pump and Delco Alternator Please ignore AC Compressor in the picture.
  4. RDavisinVA

    GM 292 Straight 6 - Yet another conversion

    292 Production Ancillary Mounts: RHD With AC Saginaw PS Pump, Delco Alternator, and Sanden AC Compressor Note picture shows 1 AC belt, but 2 will be used.
  5. RDavisinVA

    GM 292 Straight 6 - Yet another conversion

    292 Production Ancillary Mounts: RHD Without AC Saginaw PS Pump and Delco Alternator
  6. RDavisinVA

    LT95 to R380 tunnel compatibility

    Interesting enough, we have 2 110 V8 vehicles here. 1984 with LT95 and 1987 with LT85. Haven't taken exact measurements, but at a glance, the tunnels look identical. Had to swap the seat base, floors, and both tunnel sections from an early LT77 setup in order to fit an R380 stumpy when we...
  7. RDavisinVA

    GM 292 Straight 6 - Yet another conversion

    Here's what the engine adapter looks like after they have been machined. This was an adapter from the last batch that was produced for our series conversions more than a decade ago. This adapter goes between the Chevy engine and the R380 Stumpy or LT77.
  8. RDavisinVA

    GM 292 Straight 6 - Yet another conversion

    Fresh from the foundry. Picked up the adapter castings, loaded them in the back of the 110, and dropped them off at the machine shop.
  9. RDavisinVA

    GM 292 Straight 6 - Yet another conversion

    Adapters castings shipping from foundry on Monday, 7/22/19. They need to be machined into a finished product. Those of you on the waiting list for kits should locate an engine if you haven't done so already.
  10. RDavisinVA

    Stall at high rpm

    It is almost impossible to bleed the air out of a 2.5 N/A using the lift pump. Read post 11. It provides you with a solution to your problem. Ignore the last sentence if you're keeping the 2.5 N/A.
  11. RDavisinVA

    Parts!

    It is a hybrid 3.0 liter 4 cylinder with a special cam, cylinder head, and manifolds, and flywheel machined and drilled for the Land Rover clutch. Worth noting that both the engine and transmission are for a Series IIA, or III 6 cylinder vehicle. Neither the engine or transmission will fit into...
  12. RDavisinVA

    GM 292 Straight 6 - Yet another conversion

    292 kit updates: Adapter castings are due out of the foundry on 7/19. Mounts for the PS pump, alternator, and AC compressor have been prototyped and will go to production ASAP. Metal motor mounts for the engine to 4 cylinder frame are being produced. Metal mounts for engine to V8 frame are going...
  13. RDavisinVA

    Stall at high rpm

    The fuel routing on the 2.5 is terrible because it traps air and then recirculates it around the IP filter loop. Close off the banjo return to the filter with a solid bolt and install a sedimenter and 12V fuel pump to expose the air and or fuel leaks. Better still. remove the 2.5 and replace it...
  14. RDavisinVA

    This Start Problem....

    Disconnect the negative post and put a volt meter that can detect low voltage between the negative battery post while it is loose, but not grounded, and the ground cable. Does it show voltage? BTW, you cannot use a deep cycle battery for your "car battery" for long as the charging needs are...
  15. RDavisinVA

    What is this part?

    What's the part number engraved on the assembly?
  16. RDavisinVA

    Parts Dump, Cheap to Dirt Cheap

    When Brent Frazier sells, people buy!
  17. RDavisinVA

    Parts Dump, Cheap to Dirt Cheap

    Payment sent for sunroof, blem skid plate, seat risers.
  18. RDavisinVA

    Parts Dump, Cheap to Dirt Cheap

    PM sent on Seat risers with hardware, 1 set: $40
Top