Search results

https://www.roversnorth.com/parts/ext009-29_defeater_barrier_mat_black_for_defender_r380

For clarification this was not the full mating surface, just 2 areas where there was interference.

In my case I needed to grind off probably 1/8-1/4 of material to get it to sit flush.

I installed the Lucky 8 kit, which I purchased for roughly the same price as this listing, back in 2019. I can confirm it uses the drum shafts and you do need to clearance the bracket a bit to get it to install flush. I am over 4 years in, and it is meeting my needs. I don't recall all of the...

I went from two 7x7 doors to a single 18x8. Best decision ever. Only wish my garage ceiling was higher than 9.5 feet. I want to say door + side mount opener + lumber + labor was ~$3,500 all in.

x2 on transfer case popping into neutral.

My 110 is Fuji White. I definitely prefer it over the original Alpine White. For me the Alpine White always looked dirty.

I have found the folks at Safety Devices very helpful if you contact them directly. I was able to purchase some mounts from them which were not listed for sale individually.

While I would bet money that I have one, I cannot seem to locate it.

I might have one. Will need to look