Aside from the clamp not being tight enough is there anything else that would cause the intercooler hose to pop off at the turbo during hard acceleration?
I have a set of front and rear medium Terrafirma 2 inch lift springs surplus to my needs. $200 plus shipping for the set of 4. They are new and still in the boxes.
For sale is an Aluminum adapter to bolt a 200TDI or 300TDI up to a V8 pattern manual transmission:
LT95 4 speed, LT85 5 speed, LT77 5 speed, and R380 5 speed.
Fits all the manual transmissions with a v8 Belhousing.
New, but shop soiled.
$299+ shipping
I purchased this from Robert Davis in...
I had planned to convert one of my D1s to 5-speed but I already have 2 other 5-speed D1s. I’ve also kinda started liking driving the automatic. I need to recoup some of the money I have been spending on the other LR projects as well.
The manual pedal assembly was extremely hard to find and I...
I have several D1 steel wheels available. They are all in very good condition. A few have been painted black but most are still factory silver.
$40 each or $125 for a set of 4 plus shipping. Shipping has been averaging about $40 each.
This is a set of 5 wheels in good but not perfect condition. $250 plus shipping for the set or $75 each. I am planning to remove the tires for shipping. If you want the tires, they hold air reliably but are a bit old. I’d guess $40-$50 each for shipping, less if you are close to New Mexico. I...
This is a set of 4 Bora wheel spacers for a Defender / Discovery 1 / RRC. They came installed on project Discovery 1 and I have decided to not use them. Price is plus shipping. Based only on eBay research they sell for around $350-$450 new. I will get some better photos and measure the thickness...
I am looking to purchase a 1.4 ratio LT230 transfer case. I could pick it up depending on your location or would be happy to pay shipping.
Thanks,
Terry
I put 2 inch lift springs on my D1 and obviously the alignment went off. I adjusted the tie rod ends to bring it back to the steering wheel being centered and it does not seem to drift or pull in either direction on the interstate. It was surprisingly easy but wow does just a little adjustment...
I have what I would describe as a light growl when there is no load while coasting at highway speeds. It goes away under the slightest acceleration or deceleration when there is a load applied. Climbed under it and grabbed the driveshaft looking for a cause. I noticed a slight amount of play in...
I have a glass bowl sedimenter. Where is the best place to install it? I have seen them installed close to the tank down low by the frame. I have also seen them installed in the engine compartment. My thought would be as it is glass it would be safer in in engine compartment. However, does it...
As I was doing research on getting a replacement ac compressor for my D1 300tdi, I learned a lot about Nippondenso ac compressors. In a nutshell, the 10PA17C it uses is very common. There are basic differences such as a few different mounting point options, manifolds, and different pulleys...
Anybody know a belt part number that will work for the air conditioning belt on a 300tdi? I haven’t been able to cross the LR number. Hoping to get the ac done today and don’t want to wait for one to ship.
Or, does someone know the length? I’m sure I can find something close. Goodyear belt part...
On a 300tdi coolant transfer elbow (not sure what else to call it, so I attached a photo) there are 2 sensors in the with AC version. Which sensor controls what and what is the activation temperature? For those of you that will respond, look in the ROM, that is not practical at this point in...
My 98 D1 300tdi R380 conversion project is finally approaching full completion stage. When I first picked it up I was going to be satisfied cosmetically with respraying the body and replacing the LSE chrome bumpers with stock black ones while also ditching the painted bumper corners/caps for...
I apologize this is my first post here. Have been a Defendersource and Discoweb member for years. Defendersource is getting a little ad heavy.
Well, to my post...
I purchased these from forum member NPT90 last year. (He sold several to forum members at that time). I have since decided to use...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.