Search results

  1. T

    Puma hood

    I am working on a ls swap, and my clearance is real tight, I am contemplating going with a puma hood. I see fiberglass as well as metal options. Rovers north has one that looks to be steel? Would you guys go with fiberglass or metal. If metal, where they originally steel? Thanks
  2. T

    Safari gard tire carrier instructions please??

    I have acquired a used safari gard tire carrier for my hard top ROW 90. Does anybody have any instructions or advice for install? I know they were mainly used on Nas soft tops but hoping to make it work. Cheers ian
  3. T

    removing shifter knob advice RRC

    Ok guys, can't figure out how to get the knob off the shifter. Need to replace the illumination strip. I already managed to break the nice wood cover of the shifter, previous owner had super glued it together. Wonder if there is a replacement for that as well. Thanks in advance! Ian
  4. T

    Arb compressor install, rrc

    In an effort to stop the spread of covid19, I find myself at home working on some rover projects these next few weeks. I started my locker install of an arb rear. My question is where I steal power for the switches, looks like I need a switched power wire and illuminated circuit. Anybody...
  5. T

    Range Rover classic rear storage/makeover

    I am looking at cleaning up the back of the rrc. Does anybody have any pics of ways they have redone the back. Hoping to make some storage for tools, and possibly put a 235 spare back there. Couldn’t find anything searching. I would love to have a drawer system back there
  6. T

    Rrc winch bumper

    I am on the hunt for winch bumpers and sliders for a rrc. Anybody parting with any? Thanks I’m advance.
  7. T

    Wiper motor questions?

    In my defender, the wiper motor is quite loud. Is this normal to hear it over the 200tdi? On another note it never goes back to park, you have to time it right. I replaced both the stalk 1st and then the park switch. I was wondering if I got a faulty new switch.
  8. T

    Lr3 hitch for small offroad trailer

    I have a lr3 and recently purchased a adventure trailer horizon. I think they weigh about 2k. I have one of the stock Land Rover hitches (longer version), and it hang pretty low. I was wondering if anyone has and luck with the voyager rack hitches...
  9. T

    center console suggestions

    I am on the hunt for center console, I have been contemplating between a tuffy box, and the one from icon https://shop.icon4x4.com/node/78. Does anybody have one they like? hoping to lock a stereo in there and have some cup holders. Both of these still measure a little long to have the cup...
  10. T

    Defender side mirrors...

    Not too long ago, I replaced my two mirrors with new assemblies from rovers north because the old ones had stripped screws at the hinge and were quite wobbly. Just recently I was navigating through a tight spot and had to pull my mirrors back. I believe I may have done some irreversible...
  11. T

    lock cylinder help, modern style rear door.

    On my defender, I replaced the rear door with a newer style (i think 2006). This new door is amazing except it has someones lock in there. I tried my old key on the miracle that it would fit. Are the lock cylinders transferable from old style to the new style? Can i transfer over the whole...
  12. T

    are all lhd trim panels for heater controls the same?

    I am in the process of buttoning up the dash after a RHD to LHD drive swap. I ordered MWC9339PMA LHD tim panel to cover up/mount the heater controls, but the holes don't line up. Are there different versions of the of the trim panel that has different holes? Or do I have to drill new holes in...
  13. T

    Lhd wiper motor cover

    I am finishing up my dash from rhd to lhd and am looking for the wiper cover with the three switches. Does anybody know of one for sale or where to get them? Cheers and thanks in advance. I found two different ones mtc6080, and muc1382. I can always order one from England but was hoping to...
Top