Search results

I'm in

Sorry this happened! Do you suspect the oil cooler mod had something to do with it? I considered installing it but I ended up deciding against it. was concerned about possible added strain on the system.

edited my reply on wrong thread. :oops:

...Great for the charcuterie board enthusiasts..:ROFLMAO:

Worth taking a look around the fuse box for loose ground to the bulkhead

Thank you for these great gifts! Just in time as my recovery strap was on its last leg! Merry Christmas!

I'm in!

Sold.

Used set of 4 door latches from a 1986 station wagon with new locks and 2 keys. The aft right latch did not open from the inside. I never took the time to troubleshoot and ended up replacing all my doors with push buttons recently. $200 + flat rate shipping

pm sent

Last I was tracking, the first deliveries were scheduled for this month. Has anyone heard of anything actually happening or did Ineos delay it again?

The picture does not look correct. It should look like this when mounted..

Got this beautiful Red Canoe hat and patch! Perfect choice! Hard to tell from the picture but that color is awesome! I could not figure out who sent it, but Thank you very much and Merry Christmas! And also many thanks to Frank for putting this event together!

Not sure of the tube diameters but something like a wakeboard rack might do the trick? they clamp on the tubing of a ski/wakeboard boat tower

For sure, It just gives you more options for future use. It gets quite cold in the winter here (AK), so we always plug in block heaters, battery pads oil pan pads in different combinations. I do occasionally get a little snow in the plug receptacle, but it's easy to clean out the way its mounted...

Are you trying to mount the NOCO plug vertically on the wingtip vent? That may cause issues with drainage of water/ice accumulating inside the plug over time. I mounted mine like this.. I would also recommend the kit with two female ends, so that you can add other accessories i.e. trickle...

I have not been able to test mine in altitude. So far maybe 3000Ft in 60-70 temps, but but the outside temperatures in AK are starting to go below zero so I will have to wait until next year to see it perform at higher altitudes/temps. My cooling system is not plumbed the same way. I did not tap...

What about a diesel Hilux ;)

The Aux Temp sensor is installed and fits great. Now that it is fully installed, the factory gauge is functional again. However the normal operating temperature range reads a little higher than when I did the testing in a cup of hot water on post #21. The gauge ends up displaying in the gap...