Thanks for the reply. I am trying to sort out if the drivers side is harder to do than the right side.
I cut the end off the breather tube when I did the passenger side.
I put more fluid in it recently and would like to put it off till spring. The lr3 is my winter driver and I am afraid...
Is it possible to use a slide hammer with the c collar gizmo I bought and used on the passenger side. I now have a leak on the left side. If there is no room or ability to use the slide hammer to remove the half axle what is the way to accomplish this ?
As always thanks for all comments.
thanks for the reply. is a calibration tool is needed when replacing the sensor? anybody steer me to a calibration tool? thanks for any words of wisdom.
i got the struts on all around and still have the dsc kicking on around corners. the vehicle raises quickly. it does not appear to leak or sag after sitting at off road position overnight. when going around the turns the dsc kick s on and sometimes i get suspension fault light on. with...
Thanks for your reply. When I installed the rear air struts I removed the air line directly from the shock without any depressurization at the block or with a gap tool. This led to the strut moving some once the air line was loosened. To access the line the lower bolt was removed and the...
I replaced the rear air struts a few weeks ago without depressurizing the system. Perhaps this was foolish. The shock did move some.
I ordered from lucky 8. Not sure what brand they offer.
Any comments on the front and what to do there.
when replacing front air struts on lr 3 is it necessary to remove the plastic wheel well cladding to have room to remove the air hose? Do you have to go from under the hood to get the back upper bolt loose? should I depressurize the system by loosening air hose fitting at the block or is okay...
Thanks for the replies. The battery is good. I don’t hear with my untrained ear any exhaust leak or rattle. The exhaust does not have any odor or black smoke.
The cel has not come back on. Is there a place for doing anything now ?
Thanks for the reply. I was hoping the expert response would be to replace oxygen sensors and all will be good.
I used my code reader to erase and therefore turn the light off.
There is plenty of coolant in the reservoir.
Now I will drive and see how long till cel comes back on.
Any...
Hoping for a plan to resolve check engine light on lr3 with codes of p0420 and p0116.
No issues with driving but light just came on. No exhaust odors or noises from exhaust. Around 150k on the odometer. I am original owner. I have not changed oxygen sensors or coolant sensors.
Where to...
Anyone care to comment on the fix for no heat from drivers vents but great heat from passenger side on a 2017 Discovery.
Is this a common problem with a well known solution? Doesn’t seem to resolve on its own.
Maybe someone has had this before and can share their experience. Maybe a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.