Thank you. I took trhe defrost vent cover off where I could see it. Spray some lubrication down inside the area where the gear is and tap that flange down a bit with a blunt punch. It seems to be working at the moment, but I’m going to order a new wheelbox part. Just In case and remember to put...
I have a right drive 1988 Defender 110. The wiper on my drivers side has been a little wonky since I got the truck a few years ago. I have replaced the female part and the wiper are a few weeks ago. I got some really nice wiper blades that are very tight in the window. I’ve used them a couple of...
I have a 1988 3 door 110 hard side that i am need to replace the rear fuel tank. I have a front tank under my seat as well that i use daily, but the rear leaks.
I have found about 4 different possible part numbers. They are probably all similar or just an old part number, but dont want to...
I have a slow low pressure fuel drip that seems to be coming from where the head bolts to the body of the injection pump on my 200tdi I installed about 6 months ago. It?s beginning to get a little worse over the last 7500 miles ive driven the last few months. Any idea of a simpler fix than...
Thanks RED90, i have already pulled the turbo and the manifold off, so the hard part is done. i am going to make sure I can get the other cassette out before I order the part just in case its heat welded itself together) considering that the rover gods shown upon me and I didnt break any...
I was planning on buying the CHRA. Will i still need to balance it if I buy it from the the https://www.turborebuild.co.uk/websh...Cartridge.html ?
i was planning on ordering one from them then installing in my original turbo casing.
watched a video, seems pretty straightforward
thanks for...
I have acquired a great 200tdi to replace my 2.5td in my 110. Im doing a mild refurbish and clean up. Turbo looks ok. But I want to rebuild the turbo or purchase a new one if someone has one laying around for a good deal. It's a 200tdi Defender engine top mount turbo. Any recommendations on a...
I just got my hands on a Defender 200tdi to upgrade my 110. I am going to do a mild refurbish and have found most of the parts and gaskets that I need,but struggling to find a fan shroud for the engine swap. Anybody have any sources for a shroud.?
Anybody have a good recommend for a shipping company
I have a motor I am buying that's is in the San Francisco area and I need to get it to the Dallas Texas area.
Has anyone ever used Uship? I don't need it over night. Just need reputable and secure. Even if it was a couple weeks to get...
My 2.5td cav injection pump is leaking out the bottom. Does anyone know a reasonable rebuilder?
its still starting perfectly, but loosing top end on hills
I will be going to a 200tdi at some point, but wanted a little more out of the little 2.5.
thoughts?
I went with the "The Dro" 's way of cracking each injector a 1/4 turn. Started right up!). And in response to other comments. Yes. A 200 to 300tdi is in my near future;)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.