I have the new part and I've watched some videos. Is this really as simple as siphon out the brake fluid, remove nuts, swap part, bolt back on, refill brake fluid and done?
Any warnings? Tips? Tricks? Don't do this...
Thanks,
Alex
Is there a seal between the master cylinder and the servo? Asking for a leaking friend as seen in the photo.
Do I need to replace multiple parts here? And my brakes are soft. Even by 1983 110 standards…
83 d110, 300tdi
Lights work, turn signals work, just not horn. That has me assuming it is not the switch. How do I check power at the actual horn- when I hook a multimeter up too the purple and black wires there I don't have power. Then I was wondering if that is normal- doesn't matter if...
Thanks for the graphic. I have those two out, I was surprised they actually came out like they did. I thought for sure they would be harder.
It’s the 4 that go from below where the step pad is and the hitch that I can’t get to move.
I need to remove the rear step bumper and have all but the four bolts underneath/behind the hitch. Any tricks or ideas? It’s actually not super rusty I think they were just really cranked on there and it’s a tight area to get to.
And for the rear crossmember my plan is to grind/clean away the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.